Angle Setup - Pioneer PDP-50MXE20 Technical Manual

Plasma display monitor
Hide thumbs Also See for PDP-50MXE20:
Table of Contents

Advertisement

Tilt Mount Unit: PDK-5011

4.6.4 Angle setup

This installation hardware allows the display to be tilted down freely at any angle from the vertical to 25°.
This adjustment must always be done by two people.
Adjust the angle by rotating the screws at the center top and center bottom of the wall side hardware (left or right).
Note
• It is difficult turn the center-bottom screw while increasing the angle. When this happens, adjust the angle by turning
the top-center screw.
• Turn the screws very carefully to avoid damaging the wall.
• When a screw becomes tight at either end of the adjustment range, do not turn the adjustment screw any. Doing so
applies excessive force, deforming the screw.
A Criterion for the vertical location
Gap
disappears
Wall side hardware
When it is in this state, do not turn
the adjustment screw any further in
the closing direction.
Opening
Closing
A
Resin plate
108
Back of the
Plasma Display
Resin plate
Hexagon wrench
Tilt Angle Criteria
B
Angle
10°
15°
20°
25°
Angle of incline and appearance of the screw for
angle adjustment from a horizontal position on
the front (PDP-42MXE20 only)
16° or more
B Criterion when its angle is 25°
End face of the plate
Matched in both
directions
Notch
When it is in this state, do not turn the
adjustment screw any further in the
opening direction.
X
Normal holes of
PDP-42MXE20 model
PDP-50MXE20 model
Normal holes Upper holes
199 mm
191 mm
253 mm
240 mm
305 mm
287 mm
355 mm
333 mm
403 mm
376 mm
Standard hole
Upper holes
visible
23° or more
[50MXE20 : 42MXE20]
Measuring the opening distance
X provides an approximate angle
value.
X
194 mm
246 mm
296 mm
345 mm
391 mm
* Illustration depicts
visible
PDP-50MXE20 model.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pdp-50mxe20-sPdp-42mxe20

Table of Contents