Lopi GreenField GS2 Owner's Manual page 57

Optional Equipment
12. Remove and discard the screws (see "a" below) holding the stock regulator in place (see "b" below).
Remove and discard the stock regulator, spring, and gasket (see "c" below).
13. The stepper motor (adjustable regulator) has an installation sheet included with it – make sure to follow
all of the directions. Place the stepper motor on the gas control valve (see below) – MAKE SURE IT IS
CORRECTLY ORIENTED. Secure using the screws included with the motor – tighten to 25 Lb-inches.
Leak-test this area after installation to verify proper installation. Route the stepper motor wire near the
IFC location.
© Travis Industries
a
b
d
4121130
(for qualified installers only)
T-20 Torx or
Slotted Screwdriver
c
57
100-01316