Teleco UST DK User Manual page 109

–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
2. Announce the call.
3. Hang up.
4. If the station does not
answer before a
period set in system
programming, the call
recalls your station.
Call Transfer with Camp-on
You can transfer a call to a busy station from either a DSS console or a DDS. Use the [DSS] to
transfer the call, even though the [DSS] LED associated with the station you are "transferring
to" is red.
To transfer a call to a busy station
1. Press [DSS]
corresponding to the
busy station to be
called.
2. Hang up.
Add-on Module/DSS Console
With Tone signaling, you would have to wait for the called
station to answer before announcing the call.
The call rings the called station when you hang up. While the
called station is ringing, the [DSS] LED is steady red, and the
Line LED flashes green at the on-hold rate or if on a [DN]
button, it goes idle.
When the called station answers the call, the [DSS] LED stays
steady red, and the Line LED becomes steady red.
You may hear a busy tone. The original caller is placed
automatically on hold. The Line or [DN] LED flashes green at
double the on-hold rate, and the [DSS] LED remains steady
red.
The call rings the called station once with the camp-on tone.
While the called station is receiving this tone, the Line LED
flashes green (on-hold rate) or if you are on a [DN] button, it
goes idle. The [DSS] LED remains steady red.
When the called station answers the transferred call, the Line
LED becomes steady red. The [DSS] LED remains steady red.
If the busy station is in the DND mode, the call will not
Note
transfer, but will recall your telephone immediately.
Features
109