Teleco UST DK User Manual page 10

Buttons ––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Table 1 Fixed Button Definitions (continued)
Button
(continued)
(Microphone)
(Message)
10
If the held party hangs up, the call is released and the CO provides a hold-
release signal.
Note
If your telephone is programmed for Automatic Hold, existing calls are
automatically placed on hold when you answer a call or make another
call. (See "Automatic Hold" on Page 28.)
A different call can be held on each [DN] or
button on your phone. Each time you press
a different [DN] or is selected. The selected
button's LED flashes rapidly and your LCD displays
information for the call holding on that button
(samples shown at right).
Press to toggle the microphone ON/OFF while the telephone is in use. The
LED indicates the status of the microphone.
Notes
The microphone and accompanying LED are always ON when receiving
"voice first" internal [DN] calls to enable Handsfree Answerback and OFF if
you receive a ring-first call. Mic may be ON/OFF when placing an on-hook
CO line or internal [DN] call.
Each station's Mic can be set in system programming to switch ON/OFF
with one touch, to switch OFF only while pressed and held, or to be either
ON/OFF at the start of handsfree dialing.
To talkback to an HS-OCA call, press and hold Mic and talk over your
telephone handset/headset. The LED and microphone remain OFF during
OCA talkback operation (see "HS-OCA" on Page 56).
Mic functions on Handsfree Answerback and OCA calls for privacy.
When Msg LED flashes, press
device that activated the LED (see "Message Waiting" on Page 52). This is
the telephone's [PDN] message waiting button.
Press the same [DN] or
Press . The last number called is redialed.
Note
If you have Automatic Line Selection, you must first lift the handset.
Definitions
CO LINE 02
,
DN 202
to call back the station or voice mail
that you used to dial the original number.
UST DK Digital Telephone
HOLD
HOLD