Custom Speakon ® To Bare Wire Cable - L-Acoustics 5XT series User Manual

5XT
COAXIAL ENCLOSURE
user manual
VERSION 1.0
4.2 Custom SpeakON ®
The Custom SpeakON ®
using the screw terminals. Additional enclosures can then be connected in parallel with 2.5 mm² speaker wire
®
instead of SpeakON cables.
This cable is not provided by L-ACOUSTICS
Remove one of its SpeakON
white) and corresponds to a channel and polarity (1+ and 1-, 2+ and 2-).
The information given here only apply to SP cables. The color codes descibed here are specific to L-ACOUSTICS
cables and may be different for other manufacturers. Check in their documentation before any operation.
Refer to the figure and table below to know which wire is associated with which SpeakON
Wire color
5XT_UM_EN_1.0
to bare wire cable
to bare wire cable can be used to connect 5XT enclosures to a controlled amplifier
® but it can be made from an SP cable.
® connectors to reveal two pairs of wires. Each wire is color-coded (red, black, yellow and
Wire routing in a SP cable
SpeakON ® point
Red 1+
Black 1-
Yellow 2+
White 2-
Custom SpeakON ®
w w w . l - a c o u s t i c s . c o m
Transducer connector
1+ first enclosure
1- first enclosure
1+ second enclosure
1- second enclosure
to bare wire cable routing
® points.
10
®