Table of Contents
Advertisement
6.9.2
Connecting the ETHERNET Port via a Network Hub (Straight-
Through Cable)
You can connect the Ethernet port of the VS-44HD to the Ethernet port on a
network hub or network router, via a straight-through cable with RJ-45
connectors.
6.9.3
Configuring the Ethernet Port
After connecting the Ethernet port, you have to install and configure it.
For detailed instructions on how to install and configure your Ethernet port,
see the "Ethernet Configuration (FC-11) guide.pdf" on our Web site:
http://www.kramerelectronics.com.
6.10
Controlling via the REMOTE Connector
Connecting the REMOTE terminal
block connector to a contact closure
switch enables you to route an input
to an output by remote control. For
example, to route input 1 to output 4,
as the example in Figure 9
illustrates, momentarily touch, firstly,
output # 4 to the Ground, and then
secondly, input # 1 to the Ground.
In the dual-link mode, only inputs
and outputs 1 and 2 are used (as are
the INPUT and OUTPUT selector
buttons). Remote PINs 3 and 4 and
Selector buttons 3 and 4 are not
used.
16
Connecting Your VS-44HD
Figure 9: Using the REMOTE Connector
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Advertisement
Table of Contents
