Data Capture; Laser Data Capture - Datalogic Memor User Manual

USE AND FUNCTIONING
4.3

DATA CAPTURE

To capture data first of all select the barcode icon on the bottom-right side of the
display and tap the 'Capture' menu item then proceed with the following
directions.
To configure and enable data capture parameters refer to par. 4.6.
4.3.1

Laser Data Capture

To scan barcodes, point the Memor laser model onto the code from a distance
within the reading range while pressing the SCAN key.
The lighted band emitted by the laser must completely intercept the barcode as
shown in the figure below.
If the scan has taken place correctly:
- the Good Read LED gets constant Green for a configurable time;
- if enabled, the GoodReadSound emits an acoustic signal;
- if enabled, the GreenSpot projects a green spot onto the bar code image.
NOTE
Remove the protective film cover over the Laser Output
Window before use.
4
31