Batteries And Maintenance; Charging The Battery Pack - Datalogic Memor User Manual

1 2
2

BATTERIES AND MAINTENANCE

NOTE
CAUTION
2.1

CHARGING THE BATTERY PACK

The battery pack autonomy varies according to many factors,
such as the frequency of barcode scanning, RF usage, battery
life, storage, environmental conditions, etc.
NOTE
The battery icon on the Taskbar indicates when the battery pack is low.
It is possible to recharge the battery pack by connecting the power supply
directly to the Memor.
Alternatively, it is also possible to recharge the battery pack by using a Single
Cradle or the Memor Multi Battery Charger.
Moreover recharging is possible by USB Direct connection with the host
computer, but with longer charging times and only if the mobile computer is off.
During the charging process the LED positioned at the right side of the display
is red constant. Once the charging process has been completed this LED is
green constant (see par. 4.5).
If the battery pack is removed from the mobile computer, it can be recharged by
inserting it into the rear slot of a Single Cradle or the Memor Multi Battery
Charger.
CAUTION
8
Rechargeable backup batteries and battery packs are not
initially charged. Therefore the initial operation to perform is
to charge them. See below.
Annual replacement of rechargeable battery pack avoids
possible risks or abnormalities and ensures maximum
performance.
Do not use the Memor until batteries are charged for
minimum 4 hours.
MEMOR™