Installing Your Phone; Connecting The Base Station; Installing And Charging The Batteries; Connecting The Charger(S) (Office 1350 Duo/Trio) - Alcatel Office 1350 User Manual

2

INSTALLING YOUR PHONE

2.1 Connecting the base station

1) Plug the power supply
into the base station.
2) Plug the power adapter into a 230Vac,
50Hz mains socket, and the line cord into
your telephone line socket.
3) Always use the cables provided in the box
Warning: Use only the provided adaptor, using
other power supplies may cause a hazard.
Warning: Install the base unit in a position where
the mains adapter plug will reach an easily accessible mains socket.
Never try to lengthen the mains power cable.
Note: The base unit needs mains power for normal operation, not just for charging the
handset batteries.

2.2 Installing and charging the batteries

1) Place the 2 supplied batteries into the battery
compartment with the polarity markings as shown.
Use only the NiMH rechargeable battery type provided.
2) Position the battery compartment cover over the
batteries and slide up to click into place.
3) Put the handset on the base and charge for
15 hours before using the handset for the first time.
The handset will give a beep when it is properly placed on
the base or charger.

2.3 Connecting the charger(s) (Office 1350 duo/trio)

Plug the power adapter into a 230Vac, 50Hz mains socket.
If you have a Broadband line
If you connect your telephone to a line with
a broadband connection, you will need to
insert a micro-filter between the telephone
and the telephone line, otherwise you may
get interference between the telephone and the
broadband, which could cause problems.
In a home with broadband, every telephone must have a micro-filter connected, not just the
one at the telephone point that your modem is connected to.
If you need more broadband micro-filters, contact your broadband supplier.
Trim size: 148mm(W) x 210mm P5
and line cord
6
TELEPHONE WALL
SOCKET
MICROFILTER