Table of Contents
Advertisement
Lubrication
Important: Take care not to get any lubrication on
the drive V-belts to prevent slippage and damage.
If you do, replace them.
Removing Main Table
Tools Needed
To remove the table:
1.
2.
3.
4.
Important: The position of the four upper
lock nuts were set at the factory so that the
cast iron table is square with the saw blade
from side to side and back to front. DO NOT
change the position of these lock nuts (see
Figure 113). Otherwise, you will have to per-
form the time consuming procedure of bring-
ing the table back to square with the blade.
5.
6.
Qty
Trunnions
Figure 113
Figure 113.
Figure 114.
Figure 114
Advertisement
Table of Contents
