Table of Contents
Advertisement
Correcting Phase
Polarity
If this machine is wired out-of-phase, the
blades will spin in the wrong directions. If
you attempt a cutting operation with the
blades spinning backward, the workpiece
could be thrown aggressively from the table
during the cutting operation. This could
result in death or serious personal injury.
You MUST make sure the blades are spin-
ning in the correct directions before attempt-
ing any cutting operations. Perform Step 9
of the test run on Page 37 to make sure the
machine is correctly wired.
To correct phase polarity:
1.
2.
Figure 6
Figure 6.
3.
Figure 7
Make sure the incoming ground wire is
connected to the right-most terminal post
in the power connection junction box to
ensure the machine is properly grounded.
An ungrounded or improperly grounded
machine could cause electrocution.
Figure 7.
4.
Step 9
Page 37
Advertisement
Table of Contents
