Troubleshooting - Rose electronics AUTO EQUALIZATION Installation And Operation Manual

TROUBLESHOOTING

TroubleShooting
The troubleshooting section is used as a guide to understanding the capabilities
of the ViewLink CATx and for general troubleshooting. If you have any
problems or questions concerning the installation, operation or usage of the
ViewLink CATx that is not covered in this manual, please contact Rose
Electronics for technical support.
•
No video on the receiver monitor
Check CATx connection at the receiver, transmitter, patch panels (if
o
applicable)
Check HD15 video connection at the receiver and transmitter
o
Verify video is present at the video card output
o
•
Keyboard has no effect
Keyboard and mouse cables reversed at the PC
o
Check keyboard cable connection at the Receiver
o
•
Mouse erratic or not functioning
Mouse and keyboard cables reversed at the PC
o
Check mouse cable connection at the Receiver
o
•
No video, keyboard or mouse functions
Check all cable connection at the Receiver
o
Check all cable connections at the Transmitter
o
Check RJ45 connector LEDs. If the green and yellow LEDs are
o
alternately flashing, the firmware has become corrupt and the unit must
be flashed. This can occur if a power loss occurs during the flash
procedure.
VIEWLINK CATX INSTALLATION AND OPERATIONS MANUAL 11