Table of Contents
Advertisement
2-6
at the other end of the cable. You can then connect SCSI disk
drives to the connectors between the two ends of the cable. If
necessary, disable termination on the SCSI devices. (This is not
necessary for Ultra320 and Ultra160 SCSI drives.)
Set the termination so that SCSI termination and TermPWR are
intact when any disk drive is removed from a SCSI channel, as
shown in
Figure
Figure 2.2
Terminating an Internal SCSI Disk Array
Host Computer
MegaRAID 320-1, -2, -2X, -4X Hardware Installation
Copyright © 2003 by LSI Logic Corporation. All rights reserved.
2.2.
Terminator
ID2 – No Termination
ID1 – No Termination
ID0 – Boot Drive
No Termination
MegaRAID 320
SCSI ID 7
Advertisement
Table of Contents
