Lubrication - Grizzly G0460/G0461 Owner's Manual

Lubrication

The bearings are sealed and pre-lubricated and
require no lubrication during their usable life.
However, your saw components will operate
at their best if the bearing surfaces are kept
clean—this is especially important for the trunnion
bearings.
Lubricate the areas indicated below every 6-12
months, depending on frequency of use.
• Sliding table ways. Spray or wipe on a light
machine oil or lubricant (such as Boeshield
T9 ) along the entire length of the steel rods
®
(see Figure 74).
Figure 74. Sliding table ways.
-42-
• Blade height and tilt worm gears. Lubricate
with an automotive wheel bearing grease
(see Figure 75).
Blade Tilt
Worm Gear
Figure 75. Gear lubrication.
• Other pivot points. All other pivot points
under the table should be lubricated with 6 or
7 drops of light machine oil.
G0460/G0461 12" Sliding Table Saw
Blade Height
Worm Gear