Rewiring To 440V - Grizzly G0460/G0461 Owner's Manual

Grounding
In the event of an electrical short, grounding
reduces the risk of electric shock. Improper con-
nections of the electrical-grounding conductor
increase the risk of electric shock. Ensure that
this machine is properly grounded before operat-
ing it.
Electrocution or fire could
result if this machine is
not grounded correctly
or if your electrical con-
figuration does not com-
ply with local and state
codes. Ensure compliance
by checking with a quali-
fied electrician!
A fire may occur if your particular electrical
configuration does not comply with local and
state codes. The best way to ensure compli-
ance is to check with your local municipality
or a qualified electrician.
G0460/G0461 12" Sliding Table Saw

Rewiring to 440V

The Model G0461 can be rewired for 440V opera-
tion. This rewiring job consists of disconnecting
the saw from the power source, installing the
magnetic switch assembly from the 440V conver-
sion kit, and rewiring the motor.
The necessary components for this procedure can
be purchased by calling our Customer Service
number at (800) 523-4777 and ordering the 440V
conversion kit (item #P0461199).
Improperly wiring the machine may result
in electrocution, fire, or machine damage.
Get help from a qualified electrician when
rewiring your machine.
To rewire the Model G0461 for 440V opera-
tion:
1. DISCONNECT MACHINE FROM POWER!
2. Remove the motor cabinet cover shown in
Figure 7.
Figure 7. Motor cabinet cover.
-13-