Aligning Blades; Crosscut Table; Lock Plate; Adjustable Handles - Grizzly G0460/G0461 Owner's Manual

Aligning Blades

The scoring blade must be aligned with the main
blade to ensure satisfactory cutting results.
To align the blades and riving knife:
1.
DISCONNECT SAW FROM POWER!
2.
Move the blade tilt to 0° (blade 90° to table),
and raise the main blade all the way up.
3.
Unlock the scoring blade adjustment using
a hex wrench in the adjustment lock socket
(Figure 40) and raise the blade to its high-
est point using a hex wrench in the vertical
adjustment socket.
Horizontal
Adjustment
Figure 40. Scoring blade adjustment controls.
4.
Remove the stop screw from the round rail
and move the rip fence against the blade as
shown in Figure 41.
Figure 41. Fence against blade as a guide for
aligning the scoring blade.
-28-
Adjustment
Lock
Vertical
Adjustment
5.
Use the adjustment controls to move the
scoring blade so that the rip fence can touch
both the scoring blade and the main blade.
6. Install the riving knife, making sure it is
aligned with the blades.

Crosscut Table

Components and Hardware Needed:

Crosscut Table ...................................................1

Lock Plate ...........................................................1

Adjustable Handles M10-1.5 ...............................1
Flat Washers 10mm ...........................................2
To install the crosscut table:
1.
Thread the adjustable handles, with 10mm
flat washers, two or three turns onto the studs
in the lock plate, as shown in Figure 42.
Note: The lock handles have a ratcheting
action. Disengage them by pulling back on
the handle. When held back (disengaged),
the handles will rotate in either direction with-
out turning the threads. When you let go of
the handles, the internal spring will automati-
cally engage them again.
Crosscut
Table
Adjustable
Handles
Figure 42. Adjustable handles threaded into lock
plate to prepare for crosscut table installation.
G0460/G0461 12" Sliding Table Saw
Qty
Lock Plate