Grizzly G0460/G0461 Owner's Manual page 38

Figure 57. Typical crosscutting operation with
the crosscut fence in the forward position.
Mounting the crosscut fence in the rear position
(Figure 58) gives greater stability for crosscutting
smaller panels.
Figure 58. Typical crosscutting operation with
the crosscut fence in the rear position.
-36-
Forward Mounted
Crosscut Fence
This machine can also crosscut workpieces while
using the rip fence as a cut-off gauge (Figure
59).
Figure 59. Crosscutting workpieces
using the rip fence as a cut-off gauge.
Determine which cutting operation will be best
suited for the workpiece to be crosscut.
— If you will be crosscutting full size panels,
then skip ahead to "Crosscutting full size
panels" on the next page.
— If you will be crosscutting smaller panels,
then skip ahead to "Crosscutting smaller
panels" on the next page.
— If you will be crosscutting workpieces using
the rip fence as a cut-off gauge, then skip
ahead to "Crosscutting using the rip
fence as a cut-off gauge" on the next
page.
G0460/G0461 12" Sliding Table Saw