Mounting To Shop Floor - Grizzly G0460/G0461 Owner's Manual

Mounting to Shop
Floor
Although not required, we recommend that you
mount your new machine to the floor. Because
this is an optional step and floor materials may
vary, floor mounting hardware is not included.
However you decide to mount your machine, we
strongly suggest leveling the machine with a pre-
cision level before bolting it down.
Bolting to Concrete Floors
Lag shield anchors with lag bolts (Figure 18) and
anchor studs (Figure 19) are two popular meth-
ods for anchoring an object to a concrete floor.
We suggest you research the many options and
methods for mounting your machine and choose
the best that fits your specific application.
NOTICE
Anchor studs are stronger and more per-
manent alternatives to lag shield anchors;
however, they will stick out of the floor,
which may cause a tripping hazard if you
decide to move your machine.
-20-
Figure 18. Typical lag shield anchor and lag bolt.
Figure 19. Typical anchor stud.
NOTICE
We strongly recommend securing your
machine to the floor if it is hardwired to the
power source. Consult with your electrician
to ensure compliance with local codes.
G0460/G0461 12" Sliding Table Saw