Table of Contents
Advertisement
SECTION 4: ASSEMBLY
Overview
Most of your G3105 Belt and Disc Sander has
been assembled at the factory. The few pieces
that remain should go together quickly and easi-
ly. Only a few common tools are required to
assemble your Combination Sander. Specifically,
these are: 12mm open end wrench, Phillips
head screwdriver, 8mm Allen
with machine). The following list provides the rec-
ommended order in which the sander should be
assembled:
• Outside Belt Guard
• Belt Table
• Disc Table Bracket
• Disc Table
SANDING DISC
MITER GAUGE
DISC TABLE
TABLE TRUNNION
ANGLE GUIDE SCREW
G3105 Combination Sander
®
®
wrench (provided
TRACKING SCREW
TENSION KNOB
MOTOR BODY
Figure 2. Major components of the G3105.
Before beginning the assembly process, we rec-
ommend you become familiar with the Model
G3105 Combination Sander's parts and controls.
See Figure 2 below, as well as the Parts Diagram
at the end of the manual for details.
All die-cut metal parts have a sharp edge
(called "flashing") on them after they are
formed. This is generally removed at the
factory. Sometimes a bit of flashing might
escape inspection, and the sharp edge may
cause cuts or lacerations when handled.
Please examine the edges of all die-cut
metal parts and file or sand the edge to
remove the flashing before handling.
BELT TABLE ADJUSTMENT SCREW
HORIZONTAL ADJUSTMENT SCREW
SWITCH
GUARD MOUNTING KNOB
BELT TABLE
-9-
Advertisement
Table of Contents
