2.) Handlebar Installation - X-TREME XB-610 Owner's Manual

2.) HANDLEBAR INSTALLATION

1. Locate and remove the handlebar bolt,
washer & nut as shown. For access to the
nut on the back side, turn the handlebars fully
to the right.
2. Slide handlebars over post in the correct
position, then insert the bolt & concave
washer into the front (speedometer side) of
the handlebars and secure with nut on the
back (riders side). Concave washer should
be partially inserted into the handlebar and
make contact with internal post to be
tightened properly and securely.
3. Using two 14mm wrenches place one on
the front bolt from the top and the second on
the nut by reaching up from the bottom under
the fairing.
Carefully tighten
concave washer is placed correctly in the
slot.
Connecting Instrument Panel
The instrument panel is located in the seat
storage compartment, use key to open.
1) Six pin connector on instrument panel
connects to six pin connector on wire harness
on top of the handlebars.
2) Two pin connector with one Black wire on
instrument panel connects to two pin
connector with one Grey wire on wire
harness.
(Some unit may have one extra connector on
the instrument panel. If it has a two pin
female connector with Red and Purple wires
it is left empty and not used.)
** Before mounting the instrument cluster
confirm all wire connections are firmly
together and connector covers placed over
terminals securely.
10
checking to confirm