How To Align Front Forks; How To Test Rear Wheel & Controller; How To Check Voltage - X-TREME XB-610 Owner's Manual

2. Unplug six pin and one pin connectors from instrument panel.
3. Follow wire from throttle housing to white connector and unplug, (should be 3-pin connector
with black, red and white wires).
4. Loosen small allen head bolt from throttle housing and slide throttle from handlebar.

How To Align Front Forks

1. Remove the dash on the backside. Find the 12mm bolt in the center of the handlebars and
loosen it.
2. Take a hammer and hit this bolt. Stand with the front tire between your legs. Hold the tire
with your legs and turn the handlebars into position.
3. Tighten the 12mm bolt and reassemble the dash.
How To Test Rear Wheel & Controller
Place scooter up on center kickstand, turn scooter ignition in the "ON" position. Spin rear wheel
by hand and check to see if it falls in one of the following conditions:
A.) Wheel spins with slight resistance – Controller could need replaced
B.) Wheel spins hard like brake engaged – Controller and motor could need replaced
C.) Wheel spins Jerky – Controller and motor could need replaced

How To Check Voltage

Tools Needed: Multi-meter to read VDC
First be sure the battery connector from the scooter is firmly attached to the battery case. Leave all
connectors connected when measuring the voltage by sliding your meter probes into where the
wires go on the backside of the connectors.
Battery Power - 12.65vdc per battery min = +50vdc to turn on the controller.
1. Across the large Red & Black wires coming out of the controller is main power leads. Should
have +50vdc here.
Throttle measurement: Leave connector connected while measuring.
1. Locate the throttle connector on the controller, it will be a red connector with 3 wires coming
out of it of RED, BLACK & GREEN. Put you Black meter probe in on the black wire. Insert
Red probe in on the red wire and turn the scooter in the ON position. These wires are the 5v
20