Computer Diagnostic Features; Hewlett-Packard Vision Diagnostics; Accessing Hp Vision Diagnostics - HP Compaq 6005 Pro Business PC Maintenance & Service Manual

4

Computer Diagnostic Features

Hewlett-Packard Vision Diagnostics

NOTE: HP Vision Diagnostics is included on CD with some computer models only.
The Hewlett-Packard Vision Diagnostics utility allows you to view information about the hardware
configuration of the computer and perform hardware diagnostic tests on the subsystems of the computer.
The utility simplifies the process of effectively identifying, diagnosing, and isolating hardware issues.
The Survey tab is displayed when you invoke HP Vision Diagnostics. This tab shows the current
configuration of the computer. From the Survey tab, there is access to several categories of information
about the computer. Other tabs provide additional information, including diagnostic test options and test
results. The information in each screen of the utility can be saved as an html file and stored on a diskette
or USB flash drive.
Use HP Vision Diagnostics to determine if all the devices installed on the computer are recognized by
the system and functioning properly. Running tests is optional but recommended after installing or
connecting a new device.
You should run tests, save the test results, and print them so that you have printed reports available
before placing a call to the Customer Support Center.
NOTE: Third party devices may not be detected by HP Vision Diagnostics.

Accessing HP Vision Diagnostics

To access HP Vision Diagnostics, you must burn the utility onto a CD or copy it onto a USB flash drive
then boot to the CD or USB flash drive. It can also be downloaded from
burned to CD or installed to a USB flash drive. See
Diagnostics on page 32
NOTE: HP Vision Diagnostics is included with some computer models only.
If you have already downloaded HP Vision Diagnostics to either a CD or USB Flash drive, then begin
the following procedure at step 2.
1. In Windows Explorer, go to c:\SWSetup\ISOs and burn the file Vision Diagnostics.ISO to a CD
or copy it to a USB flash drive.
2. While the computer is on, insert the CD in the Optical Drive or USB flash drive in a USB port on
the computer.
3. Shut down the operating system and turn off the computer.
4. Turn on the computer. The system will boot into HP Vision Diagnostics.
28 Chapter 4 Computer Diagnostic Features
for more information.
http://www.hp.com
Downloading the Latest Version of HP Vision
and either