HP Compaq 6005 Pro Business PC Maintenance & Service Manual page 37

Table 3-6 Computer Setup—Advanced (for advanced users) (continued)
Option Description
●
●
●
●
●
●
●
●
●
NOTE:
to use the suspend/sleep feature or the Remote Management features.
●
●
Execute Memory Test Restarts the computer and executes the POST memory test.
(some models)
BIOS Power-On Allows you to set the computer to turn on automatically at a time you specify.
Onboard Devices Allows you to set resources for or disable onboard system devices (serial port or parallel port).
◦ Clear Memory = No memory count on cold boot. Clears memory on all boots.
◦
FullBoot Every x Days = Memory count on 1st cold boot on or after the xth day. No more
memory counts until 1st cold boot on or after x days. Clears memory on all boots.
POST messages (enable/disable).
F9 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text F9 =
Boot Menu during POST. Disabling this feature prevents the text from being displayed.
However, pressing F9 will still access the Shortcut Boot [Order] Menu screen. See
Storage > Boot Order for more information.
F10 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text
F10 = Setup during POST. Disabling this feature prevents the text from being displayed.
However, pressing F10 will still access the Setup screen.
F11 prompt (hidden/displayed). Setting this feature to displayed will display the text
F11 = Recovery during POST. Hiding this feature prevents the text from being displayed.
However, pressing F11 will still attempt to boot to the recovery partition. See Factory Recovery
Boot Support for more information.
F12 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text
F12 = Network during POST. Disabling this feature prevents the text from being displayed.
However, pressing F12 will still force the system to attempt booting from the network.
Factory Recovery Boot Support (enable/disable). Enabling this feature will cause an additional
prompt, F11 = Recovery, to be displayed during POST on systems with a recovery partition
on the boot hard drive. Pressing
The F11 = Recovery prompt can be hidden with the
above).
Option ROM prompt (enable/disable) Enabling this feature will cause the system to display a
message before loading option ROMs. (This feature is supported on some models only.)
Remote wakeup boot source (remote server/local hard drive).
After Power Loss (off/on/previous state): Setting this option to:
◦
Off—causes the computer to remain powered off when power is restored.
◦
On—causes the computer to power on automatically as soon as power is restored.
◦ Previous state—causes the computer to power on automatically as soon as power is
restored, if it was on when power was lost.
If you turn off power to the computer using the switch on a power strip, you will not be able
POST Delay (None, 5, 10 15, or 20 seconds). Enabling this feature will add a user-specified
delay to the POST process. This delay is sometimes needed for hard disks on some PCI cards
that spin up very slowly, so slowly that they are not ready to boot by the time POST is finished.
The POST delay also gives you more time to select
Bypass F1 Prompt. This feature allows the system to boot without pressing
when the configuration changes.
F11 causes the system to boot to the recovery partition.
F11 prompt (hidden/displayed) option (see
F10 to enter Computer (F10) Setup.
Computer Setup (F10) Utilities
F1 at the prompt
25