Heat Sink - HP Compaq 6005 Pro Business PC Maintenance & Service Manual

Heat sink

WARNING!
to cool before touching.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Loosen the four silver T15 captive screws that secure the heat sink to the system board.
CAUTION:
X) to even the downward forces on the processor. This is especially important as the pins on the
socket are very fragile and any damage to them may require replacing the system board.
4. Remove the heat sink from the processor.
When reinstalling the heat sink, make sure that its bottom has been cleaned with an alcohol wipe and
fresh thermal grease has been applied to the top of the processor.
CAUTION:
evenly seat the heat sink on the processor. This is especially important as the pins on the socket are
very fragile and any damage to them may require replacing the system board.
To reduce risk of personal injury from hot surfaces, allow the internal system components
Heat sink retaining screws should be removed in diagonally opposite pairs (as in an
Heat sink retaining screws should be tightened in diagonally opposite pairs (as in an X) to
(Preparation for Disassembly on page
(Access Panel on page
74).
75).
Heat sink 107