HP Compaq 6005 Pro Business PC Maintenance & Service Manual page 158

3. Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward
the front of the computer until it locks into place.
Figure 9-30
4. Connect the appropriate drive cables:
a.
b.
5. Replace the 5.25-inch drive.
6. Replace the front bezel and access panel.
146 Chapter 9 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
Installing a Drive into the 3.5-inch Drive Bay (Media Card Reader Shown)
If installing a second hard drive, connect the power and data cables to the rear of the drive
and connect the other end of the data cable to the next available (unpopulated) SATA
connector on the system board by following the numbered sequence of the connectors.
If installing a media card reader, connect the USB cable from the media card reader to the
USB connector on the system board labeled MEDIA. If the media card reader includes a 1394
port, connect the 1394 cable to the 1394 PCI card.
NOTE: Refer to System Board Drive Connectionson page 138
system board drive connectors.
for an illustration of the