HP Compaq 6005 Pro Business PC Maintenance & Service Manual page 98

7. If you are not installing a new expansion card, install an expansion slot cover to close the open
slot.
CAUTION:
slot cover for proper cooling of internal components during operation.
8. To install a new expansion card, hold the card just above the expansion socket on the system
board then move the card toward the rear of the chassis so that the bracket on the card is aligned
with the open slot on the rear of the chassis. Press the card straight down into the expansion socket
on the system board.
Figure 8-12
NOTE:
seats properly in the expansion card slot.
9. Rotate the slot cover retention latch back in place to secure the expansion card.
Figure 8-13
86 Chapter 8 Removal and Replacement Procedures Microtower (MT) Chassis
After removing an expansion card, you must replace it with a new card or expansion
Installing an Expansion Card
When installing an expansion card, press firmly on the card so that the whole connector
Closing the Expansion Slot Retainer