Section 7: Maintenance - Grizzly G0529 Instruction Manual

SECTION 7: MAINTENANCE

Maintenance Safety
Your safety is important! Please follow the
warnings below during this entire section:
Serious personal injury
!
could occur if you con-
nect your machine to the
power source during the
maintenance
DO NOT connect the
machine to the power
source while performing
any maintenance on this
machine.
G0529 Oscillating Spindle & Disc Sander
Check for the following conditions before you
use the sander:
process.
Perform the following tasks at the scheduled
time intervals:
Schedule
• Loose table bolts.
• Worn or damaged sanding discs or
sleeves.
• Worn or damaged wires.
• Any other condition that could hamper
the safe operation of this machine.
After Each Use
• Wipe off the sawdust build-up from
the table surface.
• Turn off power switch and remove the
switch key.
• Check for spindle straightness.
Weekly
• Wipe a lubricant such as SLIPIT
the table.
• All the bearings are permanently lubri-
cated and require no further lubrica-
tion
Long-Term Storage
• Keep unpainted surfaces rust free
with products such as Boeshield
® onto
® T-9.
-21-