Programming The Wrist Receiver Manually, Options Mode; Exercise Set; Programming The Target Heart Rate Limits; Programming The Recovery Calculation - Polar Electro E200 User Manual

C. HOW TO PROGRAM THE
WRIST RECEIVER
Note: You can also upload settings from your computer as
described in the E Series Software Manual. The software
makes programming multiple HRM's simpler and quicker.

Programming the Wrist Receiver Manually, Options Mode

Programming the Wrist Receiver via Computer UpLink
This section describes how to manually program your wrist
receiver by pressing its buttons.
The Options mode is divided into two parts, which are then
further subdivided:
1) Exercise Set: You will be able to set the target heart rate zone
limits, the recovery calculation, and two independent timers.
2) Watch Set: You will be able to set the correct time of day
and date.
Note: Once you have set any of the features below, pressing
and holding the blue button will bring you back to the Time of
Day screen.

Exercise Set

The exercise setting loop is accessed from the Options mode. You
can scroll through the setting loop by pressing either right side
button. The red button will allow you to start programming, and
then lock in your settings. Please see the directions below for
complete instructions.
12
E200 man USA C.pm6 12-13

Programming the Target Heart Rate Limits

The E200 allows you to program an ideal heart rate zone within
which your students can safely exercise. If a student goes above
the upper limit or below the lower limit, the student will be
alerted in two ways: the receiver will begin beeping and the
heart rate display will flash.
1. From Time of Day display, press the upper right button two
times. Your display will read,"OPTIONS".
2. Enter the Options mode by pressing the red button two times.
Your display will read, "Limits", with two rows of numbers
beneath it. These are the upper and lower limits of the zone.
3. Press the red button one time.
The upper limit will begin to flash.
4. Press the upper right button to increase the value of this
number or press the lower right button to decrease it.
5. Once you have reached the number you want, press the red
button once to lock it in. The lower number will now begin
to flash.
6. Press the upper right button to increase the value of this
number or press the lower right button to decrease it.
7. Once you have reached the number you want, press the red
button once to lock it in.
8. At this point you can either return to the Time of Day display
by holding down the blue button, or you can begin to set the
recovery calculation by pressing the upper right button. If this
is your choice, begin with step 3 of the section on programming
the recovery calculation, below.
Note: You can also deactivate the heart rate target zone.
To do this, press and hold the upper left button when you are
in the Limits display. The display will read, "OFF". The limits
are now deactivated. Lock in this selection by pressing the red
button. At this point, continue from step 8.
To reactivate the limits, enter the limits setting mode as
described in steps 1-2. Press the red button and "OFF" starts to
flash. Press the upper right button and the limits will appear.
18/11/02, 12:56
13