GE Security TruVision DVR 10 User Manual page 74

Chapter 5: Advanced setup
Period 1 and enter the start and end time periods for the selected day. Each day
can have up to four time periods.
Repeat for each day of the week. If the desired times for this alarm output are
identical to those for other days, click Copy To and specify the day of the week to
which you want to copy this schedule. Select All if the same schedule is used all
week. Click Copy.
4. Click Confirm to save your settings and return to the Alarms screen.
5. Copy the alarm output settings to another alarm output if required.
To copy the settings to another alarm output, select an alarm output on the Copy
to Alarm Out list box then click Copy. A confirmation message displays. Select OK
to accept.
6. Click Confirm on the Alarms screen to save your alarm output settings.
Note: The TVR 10 will prompt you to reboot in order for the schedule to take
effect.
Notifications
Notifications refer to internal errors that occur within the system. Table 18 below
provides a list of these exceptions.
Table 18: List of exceptions
Condition
HDD full
Hard disk error
Illegal access
IP address conflict
70
When alarm occurs
Hard drives are full. Notification only occurs if you disable overwrite.
An error occurred in the hard drive.
Log on failed on the unit.
Two devices on the network have the same IP address.
TruVision DVR 10 User Manual