Table of Contents
Advertisement
Switching on/off
After switching on the machine is ready for operation. The display shows
blinking LEDs. In this state, the operating panel is in stand-by mode. After you
have switched on the machine, there is no need to switch it off after each copy
job. You can leave the machine switched on for the rest of the day since it uses
less than 15 W in this mode. At all times, the Océ 7055/7056 is ready for
operation. If the machine has been inactive for more than 2 minutes, the
operating panel returns automatically to the stand-by mode. The operating
panel activates in the following situations:
you feed an original
you feed a copy material
a button on the operating panel is pressed
a roll unit is opened.
Switching on
1 Set the on/off switch at the rear of the machine, to position '1' (see figure 1).
If the mains is connected correctly, the green switch will light up.
[1] On/off switch
The machine is immediately ready for use.
Note:
Switching off
1 Set the on/off switch at the rear of the machine, to position '0' (see figure 1).
Introduction
9
Hide quick links:
Advertisement
Table of Contents
