Press the start button.
5
The copies are made and cut at the appropriate length.
After the job is completed the copy counter is set to 0. If you want to make
more copies of the same original, you don't have to feed the original again as
long as you haven't pulled it from the original feed table. Control the settings
and press the 'start' button again: the original is transported back into the rear
of the machine to prepare for a next batch of copies, and the counter
isincreased to 1. By pulling out the original the counter will be set to 1.
Making copies using the manual feed option
Press the copy material input button until the manual feed LED lights up or
1
insert a sheet of copy material in the manual copy material feed table.
Press the copy material selection button to toggle between paper (paper,
2
vellum,...) or film.
Select the appropriate copy material to avoid flawed copies. All
Attention:
materials (except for film) should be copied with the copy material
selection set to 'paper'. Only select the setting 'film' if you make copies on
polyester film 3.
Select the desired number of copies by pressing the '+' or '-' button on the
3
operating panel (see figure 4 on page 16).
Copy jobs
15