Press the operating mode button to toggle between synchro cut mode and
3
standard mode. Synchro cut mode is selected by default.
In synchro cut mode, the copy is cut at the length of the original.
In standard mode, the copy is cut at a standard length. You select the standard
length with the selection buttons. For an overview of the possible standard
lengths, refer .
Feed the original centrally and face down into the original feed table in
4
accordance with the guidelines see figure 3.
[3] Feeding an original
The original is aligned in the nip of the rollers. By inserting the material
Note:
with an amount of slack, the leading edge is aligned in the nip. A delay between
insertion of the material and the start of the transport ensures proper
alignment.
The original is transported to the rear of the machine.
Attention:
circumstances the copier can pull the original in.
Minimum length that the machine can cut is 420 mm.
Note:
14
Océ 7055/7056 User Manual
Strongly curled originals have to be fed in carefully. In certain