Introduction - Oce 7055 User Manual

Introduction

With the Océ 7055/7056, you can make copies on paper, transparent, vellum
or polyester film.
You can select between manual feed and automatic feed by pressing the copy
material input button. When automatic feed is selected, the copy material is
taken from the selected roll. The copy material is then cut. The length of the
copy depends on the operating mode you have selected. The operating mode
can be either synchro cut or standard.
With the copy material selection button you can select the copy material.
Pressing the button toggles between film and paper. You only have to use this
button if you have selected manual feed. When using automatic feed, the copy
material should be configured as a new roll is inserted.
Only use paper as is specified in '(see 'Copy material that can be used'
Note:
on page 50). Avoid storing paper in rooms where temperature and humidity are
high (see 'Roomtemperature (T) and Relative Humidity (RH)' on page 48).
Also, avoid dust and direct sunlight. Wrap unused paper in plastic to prevent
it absorbing moisture.
12 Océ 7055/7056 User Manual