A/V Installer's Guide (Cont'd) - Star Trac Pro Upright Bike Owner's Manual

• Bike Wires
• The wires will exit the bracket down onto the fitness product neck.
• Do not use tie–wraps around the fitness product neck. Use the wire
management strip instead.
• If not already attached, you will need to adhere the wire management to the
fitness equipment during your installation. Please see wire management
section in this manual.
• Hide the video and power cord within the rubber strip and Velcro to the neck.
• The mating side of the Velcro will be attached to the fitness equipment by using
the double stick backing of the Velcro provided.
Tread Wires
• Do not use tie–wraps around the fitness product neck.
• The wires will exit upward from the bottom of the bracket and toward the tread
display console.
• The tread product does not have a wire management strip like the other
products.
• Reaching up and under the tread display, you will feel the top of the treadmill
product neck. This neck is hollow and makes a great location to run all the
installed wires down to the floor.
• Use a fish tape, or other similar wire pulling device to guide the wires through
he neck.Verify the installed wires have enough slack to allow the TV to tilt up
and down without putting tight tension on the wires.
• The Bike, Cross Trainer and Stepper equipment requires the use of a wire
management strip that runs down the neck. This strip consists of a rubber
extrusion piece with Velcro attached. The treadmill product does not require the
use of a wire management.
A/V Installer's Guide (cont.)
Bike, CrossTrainer, Stepper and Pro Tread
25 25