Grizzly H7945 Instruction Manual page 11

Unloading Nails
To remove unused nails:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Point the nailer away from you and all
bystanders.
3. Slide the pusher to the rear of the mag-
azine and latch it into the lock notch.
4. Move the nails to the rear of the maga-
zine and remove them by hand.
H7945/H7946/H7995 26° Angle Nailer
Rotating the Exhaust
Cover
The exhaust cover rotates as needed to
direct the exhaust away from you.
To rotate the exhaust cover:
1. Use the 4mm hex wrench to loosen the
exhaust cover cap screw as shown in
Figure 6.
Exhaust
Cap Screw
Figure 6. Loosening the exhaust cap
2. Rotate the exhaust cover by hand to
aim the exhaust port in the desired
direction.
3. Tighten the exhaust cover cap screw.
screw.
-9
-