CyberPower RMCARD202 User Manual page 9

CyberPower Network Management System
Method 2: Using a command prompt
1. Obtain the MAC address from the label on the Network Management Card rear panel. Each
Management card has a unique MAC address.
2. Use the ARP command to set the IP address.
Example:
To assign the IP Address 192.168.20.240 for the Network Management Card,
which has a MAC address of 00-0C-15-00-00-01 you will type in the following
command prompt from a PC connected to the same network as the Network
Management Card.
1. Type in "arp-s 192.168.20.240 00-0C-15-00-00-01" then press Enter.
3. Use the Ping command to assign a size of 123 bytes to the IP.
1. Type in "ping 192.168.20.240 -1 123" then press Enter
2. If the replies are received, your computer can communicate with the IP address.
To select an IP address for the Network Management Card, please refer to Appendix 1.
7