Reset To Default Setting / Recover From A Lost Password - CyberPower RMCARD202 User Manual

CyberPower Network Management System
[System->FTP service] Allows you to enable/disable the FTP server service and configure the
TCP/IP port of the FTP server (21 by default).
Note : The FTP server is used for upgrading Firmware. For more details on the upgrade process
please refer to "Firmware Upgrade" section of this Manual.
[System->About] Displays vital information for the Network Management Card.
Items
Model name
Firmware version
Firmware updated date
Hardware revision
MAC address

Reset to Default Setting / Recover from a Lost Password

To reset the CyberPower Network Management Card to its default setting (including WEB log-in
user name and password), please use the following steps.
1. Remove the two retaining screws on the card without turning off the UPS.
2. Uninstall the card.
3. Take off the jumper on the Reset pins as illustrated.(The jumper is still necessary after reset ,
please do not lose or dispose of it)
4. Re-install the card into the expansion port.
5. Wait until the Green LED is flashing (the frequency of the ON/OFF flashing is one second).
6. Uninstall the card again.
Model name of the Network Management Card
The revision numbers of the firmware currently
installed on Network Management Card.
The date the firmware was last updated.
The hardware version for the Network Management
Card.
MAC address for the Network Management Card.
Note: the MAC address is also listed on the top of the
Network Management Card .
RESET
15
Definition