Firmware Upgrade - CyberPower RMCARD202 User Manual

7. Place the jumper back onto the Reset pins.
8. Install card into the expansion port again.
9. Tighten the retaining screws.

Firmware Upgrade

By upgrading the Firmware, you can obtain both the new features and updates/improvements to
existing functionality. There are two files to update in order to upgrade the firmware version:
- cpsrmcard202fw_XXX.bin
- cpsrmcard202data_XXX.bin
Use the following steps to upgrade the firmware.
1. Download the latest Firmware.
2. Extract the file to "C:\"
3. Open a command prompt window
4. Login to the CyberPower Network Management Card with FTP command, type
- ftp
- ftp> open
- To [ip] [port] ; EX: To 192.168.22.126 21
- Input USER NAME and PASSWORD (same as the administrator account in Web
interface default : cyber ; cyber)
5. Upgrade the cpssnmpfw_XXX.bin , type
ftp > bin
ftp > put cpssnmpfw_XXX.bin
6. Upgrade complete , type
ftp > quit
7. The system will reboot after you type "quit"
8. Login to the FTP again
- ftp
- ftp> open
- To [ip] [port] ; EX: To 192.168.22.126 21
- Input USER NAME and PASSWORD
9. Input USER NAME and PASSWORD Upgrade cpssnmpdata_XXX.bin
ftp > bin
ftp > put cpssnmpdata _XXX.bin
10. Upgrade complete , type
ftp > quit
11. The system will reboot after you type "quit"
You can check to see if the firmware upgrade was successful by checking the "Firmware version"
on the [System->About] webpage.
Note : Please do not turn the UPS off when processing the Firmware upgrade.
CyberPower Network Management System
16