CyberPower RMCARD202 User Manual page 7

CyberPower Network Management System
Figure 1. The main window of the "
4. Select the SNMP card you are setting up. Click on the Tools menu and select "Device Setup"
or double click the SNMP card you want to configure.
5. You can modify the IP Address, Subnet Mask, and Gateway address for the Device MAC
Address listed in the Device Network Settings window, as shown in Figure 2.
6. To modify the IP Address, Subnet Mask or Gateway address, enter the new addresses into the
corresponding fields.
7. You will need to enter a User Name and Password for the SNMP card (Figure 3) in the
authentication window, as shown in figure 3. *Default user name: cyber; Default password:
cyber
Power Device Network Utility
Figure 2. The SNMP card setting window.
Figure 3. Authentication window.
5
" program.