Broadcasting From Base To Handset; Redial; Receiving A Telephone Call; Broadcasting From Handset To Base - EnGenius EP801 User Manual

d. Press key to end the broadcasting.
B. Broadcasting from Base to Handset
1. Broadcast to all handsets
a. Press
key on the base station to intercom all
registered handsets.
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets
c. The BROADCAST LED will light up
d. Press the
key again and return to end the
broadcasting.
2. Broadcasting a group of handsets
a. Enter the Group ID and then press
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage.
c. Start to speak the message to be broadcasted once you hear the
"beep" sound; the speakerphone of destination handsets will be
opened up.
d. Press
key to end the broadcasting.
3. Broadcasting an individual handset
a. Enter the Handset ID and then press
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage
c. Start to speak the message to be broadcasted once you hear the
"beep" sound; the speakerphone of destination handsets will be
opened up
d. Press
key to end the broadcasting.
C. Broadcasting from Handset to Base
1. Broadcast to the base station
a. Enter the Base ID (10) and then press
b. Hear bi-bi-beep while the initiating handset
broadcast the base stations.
c. Start to speak the message to be broadcasted
once you hear the "beep" sound; the speakerphone
of the base will be opened up
key.
key.
key
~29~
d. Press the key to end the broadcasting.

Redial

A. From Handset
1. Press REDIAL (Left) softkey.
2. The LCD shows the last phone number dialed. To dial
this number, press key.
3. Use p or Key to scroll through the last 10
phone numbers dialed. Select and press
[Note] Intercom numbers (Handset ID) are not stored in
the last 10 numbers dialed log.
B. From Base
1. Press
key, after hearing the dial tone, followed by
the key, the last dialed number will be dialed.

Receiving a Telephone Call

A. Handset
1. When an incoming call arrives, the LCD will show the
caller ID message, and the ringer will ring or vibrate
unless the ringer has been turned off.
2. If the handset is on the charger cradle (ringer will be
temporarily switched to "Ring" if it has been set to
"Vibrate"), lift the handset and press
conversation.
Re: You can turn on the "Any Key Talk" from MENU-5-2
Notes:
1. You can press SILENT
the call. Unlike turning off the ringer (from the handset menu),
the SILENT key operation is valid only for the current call.
key.
key to start
(Left) soft key if you choose to ignore
~30~