Nude 2 Shock And Twinloc Remote Control Lever - Scott Spark Owner's Manual

and secure the cable by fixing the 2mm allen screw with a tightening torque of
0.9Nm/ 8lb/in as shown on the drawing below on the roll.
Contact (Roll/screw)
!!! roll position !!!
Cut the cable 5mm behind the roll and secure it with a cable end-cap.
Please refer for this action also to the manual of FOX or DT Swiss attached to the bike.
In case you need to remove the remote cable completely from the forks of FOX
or DT Swiss please follow the instructions of the related fork manuals of the fork
manufacturers or contact a fork service center / your local dealer to do so.
TIP:
To check for accurate cable tension, please try to move the plastic end cap of the cable
housing at the barrel adjuster on the remote lever. There should be "no-play" between
cap and barrel adjuster.
In case of "play" please turn the barrel adjuster clockwise until "no-play".
14
BIKE OWNERS MANUAL
NUDE 2 SHOCK AND TWINLOC REMOTE
CONTROL LEVER
In the drawing of the shock and remote lever, shown below, you will see the parts
indicated with numbers which will be used in the manual for the adjustment and set-up.
S5
S8
L1
S2
S1 Front eyelet/ Shock Bolt
S2 Rear eyelet/ Shock Bolt
S3 Shock Housing
S4 Rebound-Adjuster Knob
S5 Positive Chamber Valve
S6 Remote Control Wheel
S7 Cable Fixing Screw (hidden behind remote wheel)
S8 Shock Piston
S9 SAG Indicator (o-ring on piston)
S1
S6
S4
S7
S3
L4
L2
L3
L1 Remote Lever
L2 Release Button
L3 Remote Control Cables
L4 Cable Tension Screw Fork Remote
L5 Cable Tension Screw Shock Remote
scott-sports.com
15