At-S25 Software Default Setting - Allied Telesis AT-8316F/MT Quick Install Manual

AT-S25 Software Default Setting

LEDs
L/A (Link/Activity)
D/C (Duplex/Collision)
For information on troubleshooting the switch, refer to the AT-8316F/MT,
AT-8316F/VF, AT-8316F/SC, and AT-8324 Installation Guide.
AT-S25 Software Default Setting
Table 4 lists the default settings for the AT-S25 software that comes pre-
installed on the Ethernet switch.
Settings
IP Address
Subnet Mask
Gateway Address
Get community string
Set community string
Trap community string
Spanning Tree Protocol
Bridge Priority
Max Age Time
Hello time
Forwarding Delay
12
Table 3 Port LED Status
State Description
Solid Green This indicates a 100 Mbps link.
Flashing Green This indicates 100 Mbps activity
Solid Amber This indicates a 10 Mbps link (10/100 ports only).
Flashing Amber This indicates 10 Mbps activity (10/100 Mbps
ports only).
Solid Green The port is operating at full-duplex.
Solid Amber The port is operating at half-duplex.
Flashing Amber Collisions are occuring on the line.
Table 4 Ethernet Switch Default Settings
Default
0.0.0.0
0.0.0.0
0.0.0.0
public
private
public
Disabled
32768
20
2
15