Allied Telesis AT-8700XL Quick Install Manual
At-8700xl series switch
Hide thumbs
Also See for AT-8700XL:
- User manual (81 pages) ,
- Release note (232 pages) ,
- How to configure (110 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Allied Telesis AT-8700XL
Summary of Contents for Allied Telesis AT-8700XL
- Page 1 AT-8700XL Series Switch Quick Install Guide AT-8724XL AT-8748XL...
- Page 2 Telesis be liable for any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related to this manual or the information contained herein, even if Allied Telesis has been advised of, known, or should have known, the possibility of such damages.
-
Page 3: Models Covered By This Guide
Switch Quick Install Guide updates can be downloaded from www.alliedtelesis.com/ support/documentation/ Package Contents The following items are included with each AT-8700XL Series switch. Contact your sales representative if any items are damaged or missing. ■ One AT-8700XL Series switch. ■... -
Page 4: Selecting A Site
Allows easy access to the switch’s power and cable connections. ■ Will allow all related network devices to be connected to the switch without exceeding maximum cable length limitations. See the AT-8700XL Series Hardware Reference for cable length specifications. Installing the Switch All AC and DC versions of this equipment must be earthed. - Page 5 Mount the switch in the rack. Check the supply voltage and the switch’s rated voltage AC versions of AT-8700XL Series switches are fitted with a universal main power supply that will function over the range 100–240 VAC and 50–60 Hz.
- Page 6 AT-8700XL Series Switch Apply DC power to the switch (for DC models) Read the Safety and Statutory Information booklet before connecting a DC power supply. A copy of this booklet is included with each switch. It is also included on the Documentation and Tools CD-ROM, or can be downloaded from www.alliedtelesis.com/support/documentation/...
-
Page 7: Configuring The Switch
AT-8700XL Series Hardware Reference for troubleshooting information. 10. Check that the Power LED on the switch’s front panel lights green If the LED fails to light, refer to the AT-8700XL Series Hardware Reference for troubleshooting information. 11. Connect the Redundant Power Supply (Optional) AC models of AT-8700XL Series switches have a Redundant Power Supply (RPS) connector on their rear panel. - Page 8 Alternatively, type a question mark (?) at the end of a partially completed command to see a list of valid options. See the AT-8700XL Series Software Reference for more information on configuring the switch. Using the GUI to configure a router: This section describes how to establish a connection to the router through the GUI, so you can configure the router before installing it in your LAN.
- Page 9 Quick Install Guide router Connect the PC to the Use an Ethernet cable to connect an Ethernet card on the PC to any one of the switch ports. You can browse to the router through any VLAN, as long as you give that VLAN an IP address (see below).
-
Page 10: System Leds
Switch Port and Uplink Module LEDs. Documentation and Tools CD-ROM The Documentation and Tools CD-ROM bundled with each AT-8700XL Series switch contains the complete Documentation Set for your switch and its expansion options, as well as tools for managing the switch. This includes: ■...