Programming The Qwikbus™ System --Handset (Vhc3033-2); Programming (On Site); Programming Inside Stations For Parallel Operation - Alpha Communications STR QwikBus Installation, Programming, And User's Manual

PROGRAMMING SECTION for HANDSET STYLE
NOTE: Depending on your choice of Entry Panel, you will either be using a TT33 or TSMB3
Module. The TT33 and the TSMB3 will both be referred to in this section as the
Speaker/Microphone
Programming the QwikBus™ System – Handset Style (VHC3033-2 / HT3033)
Programming the system is easily done with two installers. One to move from apartment to
apartment working with the monitors, and one to be at the entry panel pressing the
corresponding buttons.
1. Move Dipswitch 1 at Speaker/Microphone to ON position (Enter Programming Mode).
2. Lift Handset of Apartment Station to be programmed. (Opens communication to the Entry
Panel, Installers will be able to talk to each other).
3. Press the Entry Button to be assigned to the Apartment Station (4 beeps at the
Speaker/Microphone will indicate successful programming).
4. Hang up Handset of Apartment Station.
5. Repeat Steps 8 through 10 for all apartments.
6. When Programming is completed move Dipswitch 1 at Speaker/Microphone to OFF
position (Normal Operating Mode).
Programming Indoor Stations for Parallel Operation
You can program up to 4 stations to ring with each pushbutton ( either for a residential
system or multiple stations in an apartment). Up to 8 stations can be programmed to ring
with the special TSMB3-8 module.
1. Move Dipswitch 1 at Speaker/Microphone to ON position (Enter Programming Mode).
Check that Dipswitch 2 is in the OFF position.
2. Lift Handset of Apartment Station to be programmed. (Opens communication to the
Entry Panel, Installers will be able to talk to each other).
3. Press the Entry Button to be assigned to the Apartment Station (4 beeps will sound at
the Speaker/Microphone). Hang up Handset of Apartment Station.
4. Move Dipswitch 2 at Speaker/Microphone to ON position.
5. Lift Handset of next Apartment Station to be programmed. (Opens communication to
the Entry Panel, Installers will be able to talk to each other).
6. (TSMB3) Hold down the "Light Button" while pressing the Entry Button used in Step 3.
OR (TT33) Press the same Entry Button used in Step 3.
7. Hang up Handset of Apartment Station.
8. Repeat Steps 10 through 17 for each additional parallel station.
9. Move Dipswitches 1 & 2 to OFF position.
18