Programming Vfs1500 Stations For Intercommunication - Alpha Communications STR QwikBus Installation, Programming, And User's Manual

Programming Open Voice VFS1500 for Intercommunication
You can install up to five VFS1500 stations and program them for intercommunication in the
same residence/ apartment.
To program a VFS1500 to ring when one of the numeric buttons on another unit is pressed:
1. At the Calling station, press and hold the button you wish to call the second station
until you hear a short tone. At this time the red LED will be blinking indicating that the
first station is in programming mode.
2. Go to the second station and press the ON/OFF
the system will exit programming mode. The calling station will now ring the second
station when that numeric button is pressed.
3. Repeat this procedure for all units being called from the first station, then move to the
second station and program all it's buttons as needed, then the third etc., until all units
are programmed.
NOTE: To leave programming mode without changing programming,
To delete programming from a numeric button:
1. Press and hold the button you wish to deprogram. In approx. 3 seconds you will hear a
short tone. At this time the red LED will be blinking indicating that the first station is in
programming mode.
2. Continue to depress the button until you hear the tone a second time.
The programming for that button is now deleted.
press the function
17
button. You will hear a tone and
button.