Programming The Qwikbus™ System -- Open Voice (Vfs1500/1000); Programming (On Site); Programming Inside Stations For Parallel Operation - Alpha Communications STR QwikBus Installation, Programming, And User's Manual

PROGRAMMING SECTION for OPEN VOICE STYLE
NOTE: Depending on your choice of Entry Panel, you will either be using a TT33 or TSMB3
Module. The TT33 and the TSMB3 will both be referred to in this section as the
Speaker/Microphone
Programming the QwikBus™ System -- Open Voice (VFS1500/1000 FS1500/1000)
Programming the system is easily done with two installers. One to move from apartment to
apartment working with the monitors, and one to be at the entry panel pressing the
corresponding buttons.
1. Move Dipswitch 1 at Speaker/Microphone to ON position (Enter Programming Mode).
2. Press ON/OFF Button of Apartment Station to be programmed. (Opens communication to
the Entry Panel, Installers will be able to talk to each other).
3. Press the Entry Button to be assigned to the Apartment Station (4 beeps at the
Speaker/Microphone will indicate successful programming).
4. Press ON/OFF Button of Apartment Station.
5. Repeat Steps 2 through 4 for all apartments.
6. When Programming is completed move Dipswitch 1 at Speaker/Microphone to OFF
position (Normal Operating Mode).
Programming Indoor Stations for Parallel Operation
You can program up to 4 stations to ring with each pushbutton ( either for a residential
system or multiple stations in an apartment).
1. Move Dipswitch 1 at Speaker/Microphone to ON position (Enter Programming Mode).
Check that Dipswitch 2 is in the OFF position.
2. Press ON/OFF Button of Apartment Station to be programmed. (Opens
communication to the Entry Panel, Installers will be able to talk to each other).
3. Press the Entry Button to be assigned to the Apartment Station (4 beeps will sound at
the Speaker/Microphone). Press ON/OFF Button of Apartment Station (turn off).
4. Move Dipswitch 2 at Speaker/Microphone to ON position.
5. Press ON/OFF Button of Apartment Station to be programmed. (Opens
communication to the Entry Panel, Installers will be able to talk to each other).
6. (TSMB3) Hold down the "Light Button" while pressing the Entry Button used in Step 3.
OR (TT33) Press the same Entry Button used in Step 3.
7. Press ON/OFF Button of Apartment Station.
8. Repeat Steps 5 through 7 for each additional parallel station.
9. Move Dipswitches 1 & 2 to OFF position.
15