Installation Of Fireplace; Things To Consider; Unpack The Fireplace (I60 Only); Secure The Fireplace (I60 Only) - Heatilator I60 Owner's Manual Installation And Operation

7

Installation of Fireplace

CAUTION! Risk of Cuts/Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
A. Things to Consider
• Location of chimney air kit
• Location(s) of outside air kit
• Electrical connections and/or wall switch
• Gas line piping
B. Unpack the Fireplace (I60 only)
• I60 is shipped with refractory in place.
• Remove packaging.
• Remove shipping brackets as shown in Figure 7.8.
Replace the screws removed from the fireplace.
• Remove I60 from pallet and set in place.
C. Secure the Fireplace (I60 only)
WARNING! Risk of Fire! Prevent contact with sagging,
loose insulation.
• DO NOT install against vapor barriers or exposed
insulation.
• Secure insulation and vapor barriers.
• Provide minimum air space clearances at the sides
and back of the fireplace assembly as outlined in
Section 6.
• Place the fireplace on a continuous flat surface.
• Follow framing instructions in Section 6.
• Slide fireplace into position (brackets can be used to
anchor fireplace in position).
• Skip to Section 7.G. for further I60 instructions.
Heatilator • I60, I80 • 4013-250 • Rev H • 1/11
D. Unpack the Fireplace (I80 only)
• Remove back refractory from outside of fireplace by
bending tabs up and lifting refractory out of brackets.
See Figure 7.1.
Figure 7.1 Unpacking Back Refractory
• Bend tabs back down out of the way. See Figure 7.2. Do
not remove screws or brackets from fireplace. If brackets
are removed, fill holes in outer shell with screws.
• Repeat this process to remove side refractories.
Figure 7.2 Bending Refractory Shipping Tabs
Back Down
21