Memo Record; Memo Recording; From The Answers; Message Memo Playback - RCA 25252 User Manual

NOTE: Your unit will record a message up to the maximum length of time
you set as long as the caller continues speaking. To save recording capacity,
your unit will automatically stop recording after 7 seconds of silence or if
there is a steady dial tone for 7 seconds.
The maximum recording time for each incoming message can be set in Menu.

Monitoring Incoming Calls

Whenever an incoming message is being recorded you can hear it through
the speaker if Call Screening is On. To take the call,
base or Line softkey on handset and the system stops recording.

Memo Record

You can leave a message by pressing the Memo button on base or selecting
memo recording under handset menu.
1. Press the Memo button on base or handset menu to enter memo record
mode.
Press Line1 or Line2 softkey to select the mailbox to save the recording.
2.
3. "Record memo after beep" shows in the display.
4. After the beep, begin speaking and "Recording" shows in the display.
5. Press the FINISH soft key to end the recording.
NOTE: The maximum duration allowed for memo is the same as the message
length setting in the menu.
Memo Recording (Only applicable for base)
From the Answer System Menu:
1. Press the VOL (- or +) button to scroll to Memo recording.
2. Use VOL (- or +) button to select
3. Press SELECT soft key to confirm. "Record memo after beep" shows in
the display.
4. After the beep, begin speaking and "Recording" shows in the display.
5. Press the FINISH soft key to end the recording.
Message/Memo Playback
In idle mode, press base Ans Sys button when flashing or press Play button
on handset or on base. The unit enters the message playback mode, and the
status of messages for each line
and Line 2, press SELECT soft key to play the messages.
If the unit has new messages, only the new messages will be played,
otherwise all messages will be played. Unit will play messages to the end.
Answering System Operation
Line1 or Line2 to save the recording.
display. Use VOL(- or +) can select
press Line button on
Line 1
37