SECTION 4: ASSEMBLY
Beginning Assembly
Assembly of the G1032 is straightforward. We
have organized the assembly process into steps.
Please follow them in sequence.
Caution: All die-cut metal parts have a sharp
edge (called "flashing") on them after they are
formed. This is removed at the factory.
Sometimes though, a bit of flashing might escape
inspection. Please examine the edges of all die-
cut metal parts before handling them.
Tools Required: 10/12mm open end wrench,
regular and Phillips head screwdriver.
-8-
Base
Position the base plate upside down and locate
the casters so they are within easy reach. Mount
the casters to the base plate using sixteen 10 - 24
x
1
⁄
" Phillips Head Screws provided. Figure 2.
2
Figure 2.
G1032 Dust Collector