Lan - NetComm GATEWAY SERIES User Manual

LAN

DNS
Go to Interface -> LAN to enable DHCP server. You can then set DNS server for the router. A Domain Name System (DNS) server is like an
index of IP addresses and Web addresses. If you type a Web address into your browser, a DNS server will find that name in its index and
find the matching IP address.
Most ISPs provide a DNS server for speed and convenience. Since your Service Provider may connect to the Internet with dynamic IP
settings, it is likely that the DNS server IP addresses are also provided dynamically. However, if there is a DNS server that you would rather
use, you need to specify the IP address below.
LAN Configuration
The 'LAN Settings' option enables you to configure the LAN port.
If DHCP Relay is selected, the DHCP requests from local PCs are forward to the DHCP server that runs on the WAN side. To have this
function working properly, disable the NAT to run on router mode only, disable the DHCP server on the LAN port, and make sure the routing
table has the correct routing entry.
YML14WN
www.netcomm.com.au
NetComm Gateway Series - ADSL2+ Modem Router
ADSL2+ Modem Router User Guide
25